Discussion Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a new HP8150 networked printer. It uses PCL5e commands. I am trying to set it using PCL for a DOS program to use a particular tray but it won't respond to any PCL commands I send. It prints in DOS when I capture the port to LPT1. I can send it PCL reset andwake it out of sleep mode. I can not send it PCL to use Landscape or Tray 4 and have it work however. Any ideas? Even HP doesn't know.
3 replies
by vinnyd
Try using the Generic Text driver in windows as the default printer.
That driver does not send any commands of its own to the printer.
You can also try printing the outout of the program to a file. You can use the DEBUG program or a hex editorprogram to view the file to see if the correct PCL commands are being used.
That file can be copied to the port the printer is on to see if it will print correctly.
by btr
Poster rated this answer
by btr
This question was closed by the author
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies