Discussion Locked

pcmcia network card not seen by NT

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
we have a 3com 3ccfem556b nic that's not being seen by NT. a little background info..a user has a dell latitude notebook that she took to a trade show. they attempted to put it on the network there, but because they lacked admin rights they couldn't. she goes and buys a linksys card and they attempt to install it (again that fails because of the admin rights thing) so they remove it. now she's back in our office and we have no link light on the card. all network settings are correct, removed/reinstalled the drivers, installed latest nic, pc card controller, and service pack and tried using a known good card of the same model. an older 10mbps 3com works fine but not the 10/100 card. any ideas?

5 replies

by guidos

We had a similar problem until we downloaded the Softex PCMCIA drivers from Dell's website and installed them. Seems like NT's drivers aren't quite up to snuff. You might want to try it...

by vh_s

It depends on the Service Pack you installed.

Some of 3Com PCMCIA card could only be detected when you have installed Service Pack 3 or above. Have you check on this ??

This discussion is closed to new replies.