Discussion Locked
0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I just installed a peer to peer LAN in my house and have never seen anything like this. I have 2 systems running WIN98se, w/LINKSYS 10/100 Fast Ethernet PCI NIC's, a CNET 5 port switch and I ran CAT 5 UTP. One system gives me a constant green lightat the switch, the other gives me a fast blinking light. Under Network Neighborhood all I can see is the system I'm at. I have a line tester and have a good signal end to end. What's the problem?
7 replies
Do you inadvertently have a crossover cable as one of your two connections? Hope this helps.
by morrisonk
Poster rated this answer
by dmiles
The hardware may not be installed properly,check the NIC card on machine to insure that it is installed properly
Secondly,check the cable by trying another cable to make sure that you have the correct cable and your pin outs on the cable.
You may have used a crossover cable in place of the network cable,which is reacting to the signal to the speed that it is receiving thru the cable
by morrisonk
Thanks for the help. Believe it or not, for some reason, the "Biscuit" Blocks I used must have caused the problem. I repalced that line with a pre-made cable from a system to the switch and Ta Da! It worked. Still don't understand why if the cable checked out with the tester that it wouldn't work.
by ron_tussey
I would also verify that the cables and jacks are wired to the EIA standards. This involves a pair being seperated. I have seen several times where someone just wires both ends of the cable color for color, and sometimes it works, sometimes it doesn't work at all. Plus that can cause some weird NIC reactions.
by morrisonk
Poster rated this answer
by morrisonk
This question was closed by the author
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies