Discussion Locked

Pentium 200 MMX and new Hard Drive?

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi! Here is my question,

Is it possible to make a old pc , like a pentium 200 MMX, recognize more then 8Gb; let say 30Gb hard drive. If yes, Shown me how pleaase!

Jeff
Thank you

8 replies

by kernow_boy

Yes it is possible, first check on your mother manufactors web site that there is a down loadable version of the bios that will support the HDD size that you want, if so follow the instructions on the web site ,and blow the bios on your motherboard. Then connect the new HDD boot up and the bios should recognize the new hard disk.

Hope this helps

by saihib

It's unlikely you'll be able to get a bios update for a motherboard that old. Your only other recourse is to use drive overlay software. It usually ships with new drives or you can download it from the manufacturer's websit.

by sgt_shultz

just get a $20 Promise IDE controller. time is money and that is a cheaper solution. get a performance punch also. next you'll be tempted to add RAM...yikes!

by thechas

Just to add to Sargent Schultz's answer.

Installing a PCI IDE controller card is the BEST way to install large hard drives on older PCs.

First, the controller takes care of the drive size issue as it has it's own BIOS.

Secondly, your motherboard has at best a UDMA HDD controller. Installing a new controller card will boost you to either ATA100 or ATA133. This will provide data transfer rates from the hard drive of at least 5 times faster than your on-board IDE controller.

Chas

by otl

Or you could fdisk into 4 partitions, 1 = OS, 2 = Games, 3 = Documents, and the little 6 Gig is your swap disk.

by otl

Bios recognizes 8 Gig, but with the extra drives make it look like 30 Gig, does make it easier to back-up important files though.

by pc-specialists

You have two good answers, either add a new IDE controller (you didn't say if you had PCI slots but that would be best), or, use the drive overlay that ships with new RETAIL drives. The suggestion to partition the drive is my choice whichever of the first two you use. I don't like everything in one partition. You can move "My Documents" to a different drive letter and then if you do lose the C partition, you still have all you data. Rarly does the drive just burn up so after a new format and OS load, you are back in business.

by johann2_2

You didn't state what your OS is. There is a possibility that you could format the drive under your current os using something like PQ Magic or some other and still be able to utilize the whole drive. It does depend on various situations but it has been know to work.

My situation is this! I purchased a 120 Gb 7200 rpm drive for my PII 450, The Bios only recognized it as a 64 Mb HDD. When I used PQ magic it recognized the whole (so called)* 120 Gb. (Check out the latest law suit against manufacturers.)
My MS Windows 98SE recognized it instantly.

There are so many variations according to the PC and the Bios that it is very hard to give anyone a correct answer. You can only try various solutions offered by the support given through members. We all try to help and hope that you succeed.

Good Luck
johann2_2@yahoo.ca

This discussion is closed to new replies.