Discussion Locked

Picture size changing on monitor

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a Compaq Presario 5000 US model with a MV540 15" monitor. The size of the picture keeps changing on the monitor. It goes from normal to huge. I lose about 2 inches of screen in each direction. Then later on it will go back to normal and back again.
I have updated drivers, scanned for virus's, reinstalled, all to no avail.
Any suggestions are welcome.

5 replies

by chitosunday

It is either your operating system or a virus might have disabled your anti-virus.

Try changing or updating your operating system patch-up.

If the cause is a virus, delete your operating system including its sub-directories and reinstall again. Then delete your anti-virus and set it up again. Scan your computer afterwards

by jschein

when you smack the size of the monitor, does this affect the size? lol sorry, couldn't help it...

Sounds as if your tube is in the process of going down the tube. If it is under warranty, call in for a replacement, if not, sell this at the yard sale and replace asap before you cannot see your work on the monitor.

by mark

You can try a different refresh rate to see if it can handle the signal better. Goto display in Control Panel, then Settings, Advanced. On WIN9X goto Adapter, on XP goto Monitor. If you don't see a place to change the refresh, then change your monitor to match what you have (that may fix it too). If you don't see your monitor, try the Acer 34T. It's a decent 14" monitor and Windows will show some different refresh rate settings. Generally try to use 72Hz or higher to avoid flicker. Too high and your monitor won't work at all.

by peterjones-the

Much more likely to be a hardware problem, as in the monitor is becoming defective. I am looking for answers to a similar problem on a CTX 1765d where my picture goes huge too, losing a bit off the top and bottom but at least 2" off the sides.
This could be problems in the EHT cct and/or width control (to name but a few) and I won't know much more until I can get at a cct manual.
You could try asking your friendly neighbourhood repair shop for a hint or two.
Bad news is that unless it turns out to be just a couple of simple components dying of old age, then the repair isn't economic (my monitor is dated 1996 so is well past the prime).

by faze1sari

Had the same prob on my monitor, i use the recall button on my monitor to set it square tehn i adjust the screen sixe to 840 and then bak to 1024 only thing is that it resets on restart. so i leave my comp on.

This discussion is closed to new replies.