Discussion Locked

Power Error At boot up 3.3v is at 4.08v

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
When I booted my server the last time I got a message that said there was a problem with the power supply SuperMicro ATX Full Tower Case. When I went into the bios (Asus P3B-F atx Main Board)it said something like 3.3 volt is producing 4.08v. The server has been working great. Am I frying the MB or processor. I can't get any help from the store. Their only suggestion is to replace the power supply, but they can't give me a reason for the warning or what it is hurting. Any Ideas?

3 replies

by wburdine

What does the temp setting show in the Bios after running for a half hour? If it is pushing a higher temp than what your Processor is recommended to run at and you can't adjust it down, then I would consider looking in to a new power supply. Try aSPARKLE power supply.
To answer your question, if your processor is running out of heat specs then your hurting your processor and not the motherboard at this point. Another suggestion is to get a really good heat sink like a golden orb and make sure the ventalation in the server case is moving and all cables and ribbons are out of the air flow paths and just use it.

by mikewbc

The processor temp was ok and the fans were all working. When I rebooted the server last night, it wouldn't come back up so I had to replace the power supply anyway. Thanks for your help.

Mike

This discussion is closed to new replies.