Discussion Locked

Power is on but won't boot up

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I was working inside my computer, trying to install a new PCI card. It turned out that I didn't have a free port, so I put everything back in their original positions and turned on the power. The computer then made intermittent long beeps and not much else happened. The hard drive turns on, but except for the beeping and the power/hd lights on the panel turning on not much else happens. There is no video output. The computer doesn't boot up; it just sits there and beeps incessantly. Thereis no floppy action and I don't think the RAM test runs either. I know that many things could be wrong I just need some insight as to what they may be. Thanks.

9 replies

by shanghai sam

Bios beep codes differ with each manufacturer

Award Bios one long beep indicates a memory problem,check the memory modules and make sure that each module is seated securely in the slots

Check the graphics card,you did mention removeing the cards,it may not be seated in the slot correctly,this may also explain why you are not getting a display on your screen

Check all the connectors on the motherboard to make sure none of them are loose

Site to check beep codes
www.hardwarecentral.com/hardwarecentral/tutorials/13/1

by thechas

Sounds like the video card is not seated properly in it's slot.

Double check all connectors and cards.

Consider removing all cards except the video card, and see if you can get to POST.
If so, then shut down, and add in cards 1 at a time until you can get throught POST with all cards the way things were.

Note: for most newer ATX motherboards, you need to physically switch off or unplug the power supply to safely remove and install cards.

Chas

This discussion is closed to new replies.