Discussion Locked

Power Problem

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
It seems as though my power button does not work sometimes. If I push the power button, nothing happens, I then unplug the main ATX power connector and plug it back it and then it will power up with the power button. Is this most likely a faulty power supply? Also, it seems that my BIOS drops the Primary Slave hd, and it forces me to manually enter it in the BIOS setup. What is going on here. Same problem, two different?

5 replies

by guruofdos

It sounds like the CMOS battery is borderline. ATX power supplies use logic switching and this depends on the battery to maintain the state of a flip-flop on the motherboard. The same battery keeps track of CMOS settings and most ATX motherboards will autodetect the boot drive pn each poewr-up(usually primary master) but only detect secondary or slave drives if asked to by CMOS setup.

Change the CMOS battery and see what happens. This is a common fault on certain earlier Packard Bell socket A boards, where the CMOS is under constant battery power, i.e. the battery is not bypassed when the power is applied.

by goodoyster

My apologies if this is too simplistic, but are you holding the power switch for a few seconds? On many systems the power switch must be pressed for 4 or more seconds before it will shut off. Many motherboards allow you to set the switch to instant off, either by where you plug in the switch on the mobo, or in a bios setting. Hope this helps.

This discussion is closed to new replies.