Discussion Locked

Power Supply

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

My Aopen ATX 300W Power Supply works OK when first powered, but on reset, restart or turn off at PC switch then restart fails and there are 3 Beeps from BIOS. (MotherBoard is MSI KT333 #1, AMD Duron 1G Pcu, 256Mb DDR PC2100 Ram.) CPU fan is operating OK.
Disconnect Mains Power from the power supply, then re connect Mains power to the PSU and switch PC on and it Boots up correctly and operates correctly until switched off, reset or restarted.
Mains power MUST be completely cut from the PSU before a restart is possible on ALL occasions.
Warranty has been rejected Service Distributor claims PSU is OK. (Aopen Case and power supply purchased just 14 days ago today.)
Another Power supply fitted and all works as it should.

5 replies

by rgrowcock

Sounds like it is the power supply, especially since you replaced it and the new one worked fine. I would put pressure, if possible, to have them honor the warranty. Did you explain to the distributor the fact that a new PS works fine?

If this is a small firm, they may be reluctant to replace due to the fact that it takes time to have one replaced. If it is a larger company, and if they are national, call their main headquarters. A lot of the time the main headquarters do not know what the local stores are doing. Or talk with the manager if you haven't already. Some places still believe in the old adage "The CUSTOMER is always right." Although this is becoming a thing of the past.

You could also get a Power Supply tester, I sawone available from www.compusa.com for about $15. You would have to spend more money, but it might tell you one way or the other about your current PS. Good luck.

Roger

by thechas

The power supply likely meets "bench test" specifications.

What is happening, is that the voltages are comming up either 2 slow, or out of sequence for your mother board.

So, what you have is more of a compatability issue.

Depending on how heavily loaded your system is, you might want a 350 or 400 Watt supply anyhow.

With Socket A, and P4 systems, I use 300 Watts as an "entry" level supply. I use 350 or 400 Watts for any power user.

Chas

This discussion is closed to new replies.