Discussion Locked

power supply

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

hi to all,

what diode and transistor that i'm going to use if i use a 3 amphere transformer with an output of 12 volts and 5 volts dc. and how to make it as an auto shut off if thier is any default will occur, such as a changes of current or soon.

thank's

John

5 replies

by donmars

This question makes absolutly no sense... sorry! Please have someone rewrite it for you. Someone who understands a little electronics and grammar.

by mckaytech

This probably isn't the best forum for your question but I'll give it a try anyway. If you're starting with a 3A transformer (you didn't specify the voltage, but I'll assume something like 18v center-tapped), you should probably use a 6a/50v bridgerectifier. Put a large capacitor across that and then use two voltage regulator ICs (something like an LM309K) to provide the correct output voltage. This chip will provide auto-shutdown in case of an output short but for other types of shutdown, you'll need to use something like an LM723 with an external pass transistor (my favorite is the 2N5884) and some additional logic.

paul

This discussion is closed to new replies.