Discussion Locked

Power Supply Fan

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I'm having problems with power supply fans making strange noises. The pwer supply itself seems to be working fine and power and heat read outs are normal and it does make noise all the time. I've already replaced it once because it seem to be getting worse and more frequent. Now the new one started doing it to. I cleanned the fan and that seemed to help, but it still seemes to be growlling. What is the problem? Any help with this problem is greatly appreciated.

11 replies

by ds9

Hi,

Check the mounting screws. They may be to tight, and it is warping the plasctic fan housing.

Loosen all screws, when re-tighting, once thay start to bottom out, DO NOT over tighten. Only one quarter turn after bottoming, at most.

Cheers
George

by adam smith

If it has run for a while and then started up, I'd be suspicious that it is running backwards. I replaced a customer's power supply fan (their third fan), which had been growling before it died, only to discover that the pins on the power supply board were wired backwards. Swapping the leads on the fan connector did the trick.

If you opened up the power supply and found an unusual amount of dust, it could be a sign that the fan is running backwards and sucking air into the power supply. Goodluck!

by danpiers

The growling noise you refer to is probably due to the failure of the fans bearings. These fans come with two kinds of bearings: sleeve and ball bearings. The sleeve-bearing models are usually the least expensive but generally begin to fail ina year or two. The ball-bearing models cost more but my experience is you get at least three years or more from them. Of course, excessive dirt/dust reduce the lifespan of either type.
When you install a replacement fan, make sure that it is blowing the correct direction. If the power supply is located towards the top of a tower case (or anywhere in a desktop case), it should be forcing air out of the case. If it is in the lower half of the case, it probably should be blowing in and assisting a higher fan that is blowing out. Do NOT reverse the power plug to change fan direction! The fans are designed to spin only one direction and spinning the inappropriate direction can greatly reduce bearing life. Turn the entire fan around (by removing and re-mounting) to change the aif flow direction.
Another note...buy your fans from a reputable source. I have seen fans labelled ball-bearing that were actually sleeve models re-labelled! Good luck.

by donmars

On the side of the fan there is usually an arrow indicating the direction it blows to, check the draft and note that it follows the arrow. I have had success removing the small round hub cover and adding a drop or two of machine oil (3 in 1 type)always helped. These are all EXCELLENT answers by the way, I am impressed!

This discussion is closed to new replies.