Discussion Locked

Power Supply - Power Switch

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi, I have the following problem: I have 5 cables coming out of the power supply which belong to the power switch. But, I do not know the right color order to hook them up into the switch. Here is the ling of a little web site that I build if u can help me out. http://www.geocities.com/grosero0727/

Thanks, for ur help

7 replies

by thechas

I assume that this is an AT style power supply.

The switch uses only 4 of the wires.

On the one I have in front of me, the wireing is as follows;

With the switch terminals pointing up, looking down on the switch from inside the case

Brown Blue

Black White

You should verify the wires with an ohm-meter.

The black and white should be hot and neutral from the AC line in jack on the back of the power supply.
Brown and Blue should be hot and neutral on the AC out receptical on the back of the power supply.

Then, check the switch.
With the switch in, Brown and Black should be shorted together (0 ohms) and Blue and White should be shorted together.

If there is a green wire, that is for safety ground.

If this is an ATX power supply, I have no idea what 5 seperate wires would be for.

Chas

by thechas

Checked your web page.

My answer should do the job as you have the switch setting the wires should be;

Brown Blue

Black White

The green wire should go to chassis ground.

Chas

by rcom

This is a switch and cables ends to an AT power supply ATX supplies don't have this cable. The green cable is a ground and can be screwed into the metal of the case.

As you look vertically at your first picture, just make sure white and black are not on the same side (right and left). If you connect them on the same side it will let the smoke out of the power supply (blow it). Since it's just a in/out switch it doesn't really matter which side white or black goes on. Also don't turn it on without a load that may also damage it. So if you want to test, connect a drive or something first.

Chas is correct White/Blue go together and Black/Brown are on the other side.

by rcom

Oh, The black and white wires go on the front and the other 2 connect to the slanted plugs.

This discussion is closed to new replies.