4 replies
by cmicaletti Accepted solution
by norehca Accepted solution
If the computer wont power up its the power supply or your motherboard is fried. It is NOT your hard drive. A computer will atleast boot up even without a hard drive.
Check connections first, then try a different power supply. If that doesnt work I would say your motherboard is fried. Even if the CPU or RAM is either the incorrect type or fried, the computer should still boot up, and you will hear beeping that will tell you somethings wrong.
by dr dij Accepted solution
remove boards one by one to see if power stays on. Sounds like something is shorting out, and the PS responds by shutting off to protect itself.
I actually had a PC where when I plugged a certain monitor into the VGA it would shut down. The monitor somehow was drawing too much power. A dift card didn't have this problem, and other monitors didn't.
Try the video card with and without the monitor plugged in. and unplug all external cords not needed. Try the kb also unplugged.
(to avoid boot process, put a boot password, so you don't have to wait till it boots to shut off and try again)
Also, I think it will shut off if certain things NOT detected.. e.g. power won't go on if mb cables not on correctly, etc.
by hal 9000 Accepted solution
The ATX Power Supplies require a signal from the M'Board to keep running. Normally they run for a second or so and then turn off if they don't get the necessary signal to keep running so you see fans flick slightly and stop. As for the LED on the M'Board ATX Power Supplies switch on the Neutral Link not the Positive link so there is always power present to any M'Board while the mains are plugged in and the power switch turned on.
I would be looking at the insides of the computer and see what's there any great amount of dust and other crud can mean a dead PS and if there isn't a decent Name Brand PS in the case replace that with a Know Good one and try again. If that doesn't work you can try the old PS on a Known Good M'Board CPU & Ram configuration and see if that works. Just remember that you run the risk of destroying the M'Board if the PS is faulty and possibly the entire thing as I've seen cheap PS's allow mains power inside a case so make sure that you are not touching anything when you apply power.
Generally it's the PS but if you have a cheap nasty one in the case which will be 99% you can also kiss away the M'Board as well. If you have a good brand name PS it will protect the internals of the computer by sacrificing itself. I've seen one Antec true Power supply die when a tree fell onto the overhead mains and brought the 30 KV into contact with the domestic mains. I replaced the PS and the unit worked for the next 3 years without a problem and was decommissioned at the end of the tax cycle still working perfectly.
Col
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending