Discussion Locked

powersource performance

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a pc box with a powersource that supplies rated 250 watts. I originally used it with an AMD k6III 400 processor. I am now using it with an AMD athlon 950. I really enjoy the upgrade, haha, non the less, I was planning on buying like about a 1.4ghz AMD processor but have been told that I need a 300 watt powersource for anything over 1.0ghz. does anyone have an opinion on this issue?

5 replies

by thechas

There have been a few updates to the power supply specification since the days of the K6 III.

The issue here is that the Socket A and P4 motherboards place different demands on the power supply than the Supper socket 7 board.

Your sources are correct that you should change the power supply. As to how big a supply, that depends on what is in your system, and what you plan to add to it.

If you have multiple drives, more than 128MB of ram, a high power video card, and extra fans, the power requirements add up quickley.

I nearly fried a 250W ps on a low end Slot A 500 MHz system with both a DVD-ROM and a CD-RW drive.

For any "new" system, I am using AMD approved 300 Watt supplies.

I have one system that I am considering stepping up to 400 Watts.

by yacco

Upgrade the p/s and spend a few extra bucks to buy a quality unit (Antec, Enermax, Sparkle, etc.).
Todays' high performance components have some very tight power specs. An el cheapo 400w may not be as stable as good 300w.

This discussion is closed to new replies.