Discussion Locked

press F1tocontinuepressF2 to enter setup

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a micron p166 and I booted it up the other day. I noticed that while going throught the boot process, I suddenly get the message "Press F1 to continue or press F2 to enter setup". Several things I have done was use the ERD disk and I get thesame error message. I even turned off the computer and started it back all the hitting F8 in order to see if I can step through the boot process or even boot in safe mode. I believe the hard drive might have gone bad. If any has seen this before I would appreciated any help. Thank you.

Markus Bertel

7 replies

by adam smith

Have you pressed F2 to enter setup? You didn't state whether you did or not. Sometimes, especially after adding RAM (which it doesn't sound like you did), older BIOS' get confused and freak out. Simply entering the setup and checking that everythingis in order sometimes does the trick and it doesn't hurt to just look :) In some instances, the BIOS will correct itself without prompting you. It just wants your confirmation by going into the setup, looking at the new settings, and saving on exit.

Otherwise, if it was the hard drive, most systems will tell you "Primary Fixed Disk Failure" or a similar message.

As a final check, make sure your keyboard is still plugged in. Usually, this comes with a "Keyboard Failure" error though. Good luck!

by danpiers

Everytime I have seen this message, the cause of the message was printed on the display just above it. Typically, the failure is a floppy or harddisk failure, but there are plenty of errors that can result in this message. If it is a harddisk failure, turn the system off. Go inside the case and try re-seating the cable from the harddisk to the motherboard (at both ends). If two drives are connected to the same cable, re-seat all three connections. Re-start the system and see if that helped. Sometimes, a thorough inspection of the CMOS Setup settings will reveal a problem. I have seen this message appear because someone told the CMOS that there were 2 floppy drives when only one was actually installed. Of course the memory point thelast writer mentioned needs to be checked, too. Good luck.

by vertex

Not too sure if my experience is the same, but what happen in my case was the CMOS not able to save to ROM. My initial thought was the CR2032 battery but after changing that I still get the same error message. Finally I clean the contact point for the battery and I was able to avoid the F1 to Boot message. I still need to go into CMOS to save the setting before the system boot-up normally.

This discussion is closed to new replies.