Question Locked

pri master hard disk:S.M.A.R.T. Status Bad, backup and replace

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I rectenly bought 2 computers

the specs are:

E1200 dual core celeron
P5VD2-VM SE motherboard
1GB Corsir 667 MHz ram
Pioneer DVR-115D IDE DVD Drive
Seagate 160GB IDE Drive

Whenever i connect both devices on the same IDE cable, the error message comes up - pri master hard disk:S.M.A.R.T. Status Bad, backup and replace.

It reconizes the IDE drive but not the dvd drive.

If the ide hard drive is connected there is no error message.

-

If one drive is used the bios would reconize the drive.

I have tried using the hard drive as master and cd rom as slave and vise verser still no success

The issue is that the motherboard has only one IDE outlet, so the two drives must be on the same cable.

The strange thing is that i have two of these computers, one seems to be working with the concept, the other one is not.

Any advise is great.

4 replies

by older mycroft

You could try buying a new IDE cable.

It would be the cheapest way to check.

by oh smeg

The HDD and DVD Driver need to be jumpered to Master & Slave with the Master fitted to the end of the IDE Lead.

So if you are using the unit the DVD Drive would normally be on the end of the lead so it needs to be set to Master. The HDD plugging into the middle connector needs to be set to Slave.

The IDE Cable should be a 80 Way cable so if it's not replace it with one of the correct type.

If the 2 systems are identical and one isn't working the obvious thing to try is swapping parts over to see if you can make the nonworking one work or test parts from the Nonworking one in the working one, which ever you prefer to try. Start of with the IDE Data Lead and try that in the working computer and if that works look at swapping the drives 1 at a time to test in the working unit. If that still fails to produce a problem swap the Power Supply over. If one is marginal the other may be low and not producing the correct current or voltage to allow the second one to work. Most noticeable if these are unbranded Power Supplies or ones without a known Brand Name on them. Most PS's in cheap cases fall into this category and shouldn't be used as they run the risk of destroying the computer when they fail which will always be sooner rather than latter.

Col

by redter

I'm afraid the short and simple answer is that you will be unable to connect both devices to a single IDE cable.

A HDD is just not compatible with the much slower DVD or CD drive there is no way around this jumpers or otherwise.

The error message could be a sign of a faulty HDD that will or has already failed so if there is any important information on the drive ensure it is backed up.

An alternative is to have your HDD connected to the motherboard and use an external enclosure for your CD-ROM/DVD drive. They can be as cheap as ?10.

This discussion is closed to new replies.