Discussion Locked

Printer doesn't hold power

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I'm a Printer Technician and have been working with all types of Printers.I have noticed a eunich problem with HP Deskjet 1220c printers.the problem is you switch it on and the green LED to show the printer is ready only flashes for a few seconds and switches off aand the printer wont print.I'm having problems with a couple of this series i have tried to open it to check the connections to the switch and did not find any problems

5 replies

by dennis2841

The Deskjet 1220 has a soft power on switch, i.e. the power on is a momentary switch and therefore does not directly switch power. The fact that you get a power on light response at all says that the switch works. All the power switch does is tell the power supply to exit the "standby mode". Either there is an overcurrent situation and the power supply is shutting down to protect it's self or is defective. There is also a possibility that the main board is telling it shutdown. Bottom line: It'sdifficult to diagnose these without substitute parts. If I had to bet, I would say that it's the logic board

This discussion is closed to new replies.