Discussion Locked

Printer driver

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a Dell Dimension 8200 and a Canon MultiPass C5500, I have Windows XP and the MultiPass is only two years old. I have downloaded the driver and everything that was needed from Canon to make the Multipass compatible. It will not work and I havetried everything. Is there anything I can do to make it work with Windows XP?

5 replies

by dmiles

Apparently you have checked the driver for compatibility,you possibly could use the W2K driver software to see if this one would work

by thechas

Which file did you download?
The 800K, or the 24MB?

The 800K file is for updating W2K systems to XP.

If this is a clean install of XP, (or the printer was not installed in W2K) you need the full 24MB xpc5500.exe file.

If you tried installing the driver from the CD that came with the printer, that might be part of the problem.

Start by downloading the XP compatability updates from Microsoft.

Then, remove the printer, and un-install the software.
Shut down, and disconnect the printer.

Run the xpc5500.exe file
When directed to, shut down, and connect the printer.

If you are connecting via the parallel port, make sure it is set to ECP/EPP mode in BIOS settings before starting the installation.

Chas

This discussion is closed to new replies.