Discussion Locked

Printer Problem

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a Declaser 5100 that worked fine until a few days ago. When I power it on now, it either prints out a solid black or blank page and just sits at the Startup Page on the screen. If I open the printer it goes to the Ready/Idle state, but will not print anything. Not even a test page. I tried reseating the memory cards, changing the connection, powering it down overnight, conecting it to a different system and from a different power outlet. Nothing helped. It doesn't seem to even respond tothe buttons on the front.

Is there a way to hard reset the printer? Anyone know what is wrong with it? This is a great printer (1200 dpi 8ppm) and I hope it isn't dead!!! Help!

5 replies

by ann777

There are two manuals for your printer here... you might want to e-mail him if you cannot find your own manuals and lookup how to reset the printer. ( http://vt100.net/dec_manuals )

Past experience with HP printers.... totally black pages are usually the result of a defective toner cartridge. Totally blank pages can be because the pickup rollers are picking up multiple sheets or many various other causes.

Which what you describe, I'd suspect that the logic board is shot or not properly reconnected. The link below:

http://www.dttservice.com/printers/decprinterparts.html

Has some parts and prices for those parts.... but if you've never worked on a printer... then I recommend you take it to an authorised repair center.

by alpha-male

Sounds to me like what you have is a problem with the "Video Controller Board" (what it is referred to by Digital - it's the small systemboard the memory connects to). If it is removed, the system will print blank pages. The black page may just be afreak occurrance of it trying to work intermittently, but failing.

First off, I would check the cables connecting to that board. If they are loose or damaged, that may be the issue. The board itself is a pretty spendy repair ($200+ from Compaq)...so only you can tell if it's worth that to you. Another option may be to keep your eyes out on Ebay for another 5100. I've seen them go for under $50 and you can always move your memory, 1200 dpi expansion, etc over to the new system and keep your old printer's bits as spares.

Good luck...hope this helps!

This discussion is closed to new replies.