Discussion Locked

Printout has streaks

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My laser printer produces printout with streaks running from top to bottom. What is the probable cause?

11 replies

by dklippert

Get a new toner cartridge.
You can try taking the cartridge out and re-disributing the toner by tipping it.

by trackhappy

Don't rule out the fuser. They can lose part of the coating and the toner builds up on the damaged area.

by opatzg9

fuser/ toner cartridge replacement/ there is also cleaner paper you can buy which if toner merely spilled in your machine it will pick it up after a few passes through. A good thorough vacuuming might not hurt either. Most likely just replace toner cartridge if that's the type system you have. Scratched fuser will continue the problem though and a little more spendy to replace.

by rcom

This is caused by a dirty or worn corona wire on the top of the toner cartridge or there may be specks of dust or something on the glass in front of the mirror. These can often be cleaned using a q-tip or the tool included with the printer. There's usually a slot or opening of some type for this. If it's exposed do not touch the surface of the toner roller it' usually a greenish color. Also don't leave it in the light.

As mentioned the fuser may have scratches, that's easy to see and test. The fuser is the heating element of the printing process. To perform a check start a print then open the printer before the paper has a chance to reach the fuser. If the lines are already there then its the corona wire.

If you vacuum the printer out, realize that unless you have a hepa filter the small toner particles will pass right through the filter/bag of most vacs.

This discussion is closed to new replies.