Discussion Locked

Prntr on A/Bswitch working slowly one PC

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have 2 identical Compaq Deskpro EP330's that share a hp deskjet printer via an Belkin electronic A/B switch. One PC prints fine, just like it had the printer attached directly to its parallel port. The other prints very slowly. It takes 15 minutesto print one page. The Belkin website suggested disabling the bi-directional communication that HP likes its printers to do. I have disabled it both in Windows and in the BIOS. I have downloaded updated drivers for corporate users, leaving out all the proprietary garbage hp includes on its cd. Any ideas on how to make the second PC print normally?

8 replies

by bchesmer

It may sound stupid, but have you tried switching the cabeling or the port on the belkin box? (Switch the fast PC's Cable/Port to the slow one & visa/versa).

by dj61

Yes, I have switched the cables and sides of the switch. The fast one is still fast and the slow one slow.

by dj61

Cables are brand new as is the switch. all connections are shiny and without defect.

by bchesmer

What happens when you connect the (Slow) PC directly to the printer?

Please comment back with the info.

Note: If you have the same problem when you try the suggestion above, the only things I can think of are:

1. A bothced install of the drivers are causeing problems (And will continue to do so until you manually remove ALL references to the printer & drivers from the harddrive & registry).

2. A bad install of the OS.

3. A bad paralell port on the slow PC (Try printing to anotherlike printer to see if you get the same results).

Hope this helps.

Bryan

by dj61

The "slow" PC works fine when connected directly to the printer, or connected across the network with the printer shared on the other PC. I have removed the driver and installed a new one from HP. I suspect it could be a bad parallel port, but the printer works fine when directly connected to the PC.

This discussion is closed to new replies.