Question Locked

Problem With New External Drive Using USB External Case

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I bought a brand new Maxxom 300 GB internal drive. I have hooked it up to my XP Notebook using a Mad Dog USB External USB Case. I have hooked up two other drives like this without any problems at all. The Mad Dog case comes with its own power supply, but I still plug in the usb cord directly into my laptop usb slot anyway. Windows XP recognized the new MASS STORAGE DEVICE at once, as it did the other drives when I connected them in the same manner. It assigned it a letter, just like it did to the other drives I connected, but I cannot format or partition the drive at all. Under "Properties" it shows it being full... It is brand new. I have tried Partition Magic 8 to format and partition the drive... no luck. What can I do. The XP disk management is of no help because it ands well as Partition Magic 8 see the drive but will not format ir or partition it. Thanks for your help!

7 replies

by hal 9000

Does the Case have a upper limit on the size of the HDD that it will support?

I've used up to 280 GIG without any problems in USB Caddies but not any bigger yet.

As I can not find any information of the drive I'm not sure what else to suggest.

Col

by john

I just did the same thing with a 250 GB hdd. I put the new drive in my PC, disconnected the HDD in there, and used an XP pro disk to format the drive. It wouldn't work until I went through the steps of loading windows. After it was formatted, I took the drive out, placed it in the enclosure and connected via the usb cable. It worked perfectly after that. Just delete the windows folder that gets installed.

by columbiagreek

Mine is a HP Laptop... so the 300 GB drive would not "fit" in my computer. :)

I also utilize Windows XP Home Edition.

As I said, this has never been an issue so I am baffled. Usually, I just plug in the USB cable after I install the drive in the case by hooking up the power cable and other cable inside of the case, screwdrive it closed and it is good to go when I power it up...

by columbiagreek

Yes, the case states that it can handle up to 400 GB drives...this is a 300 GB drive and easily fits into the case. I have another 300 GB drive in the exact same MAD DOG external drive case that works perfectly. I just do not get it... All of a sudden, problems where there have been none before. (By the way, the other 300 GB hard drive mentioned here is not a MAXXON...). Thanks for your help!

by hal 9000

What are the jumper settings on the HDD that's not working? With 3.5 inch drives they should be Cable Select and no jumper on a 2.5 inch drive.

I've only ever seen a size limit on one 2.5 inch enclosure of 100 GIG capacity so maybe it's the enclosure failing as I've had a couple of those or the HDD isn't suitable for that application.

Col

by columbiagreek

Okay... I fixed the problem! All that I needed to do was remove the JUMPER on the drive and it worked perfectly! All is well! Of course, I had to use Windows Disc Management to initialize and then quick format the drive... but it was a cinch! Thank you!

This discussion is closed to new replies.