So the BIOS Clear shouldn't be an option unless someone has messed with the M'Board.
Here however what Make & Model is the RAM that you have fitted and where is it installed.
The EP45 M'Board use Dual Chanel RAM and if you use the wrong type of RAM or fit it to the wrong sockets this can stop the M'Board from starting.
Also with the 775 Intel CPU's it is possible to incorrectly fit them to the CPU Socket which can have the same effect. So you need to remove the Heatsink & Fan unlock the CPU and remove it. Carefully check the CPU Socket for any Bent Pins and if there are none refit the CPU so that the 2 Plastic Bars lock into the CPU Cutouts.
If there are any bent pins in the CPU Socket buy a new M'Board as the unit will not be likely to work and this is not covered by the warranty.
If it is still not working and you have a Known Good Power Supply remove all of the RAM and try turning on again. If you do not hear a series of Beeps from the M'Board remove it from the case and lay it flat on either an Anti static Pad on a bench or clean white paper connect a Power Supply to it and a Video Card and Monitor and try turning on again. If it works now carefully check the case for the correct positioning of the M'Board Standoff's and move as necessary then refit the M'Board.
If it doesn't work disconnect the Power Supply Video Card and Monitor turn the M'Board over and look for any burn marks on the back of the M'Board where a incorrectly placed standoff has shorted out.
If there are any burn marks you'll need to replace the M'Board.
Post back if you need any more help.
Col