Discussion Locked

problem with serial printer

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

i have a serial printer connected to a pc
but it do not work
if i connect my rs-232 tester (break out box)on the back of the printer everything is fine
if i remove the rs-232 tester the printer stop working
is anyone have an idea for me

5 replies

by pvp

Two things come to mind: get a new printer cable, or get a shorter printer cable.

Since it works with the breakout box, it doesn't appear that there are crossed, broken or missing lines in the cable.

But the breakout box may be accidentally boosting the signal strength, which makes me think the cable may be too long.

by vinnyd

Printing on a serial printer may require handshaking to be done.

Your breakout box may be looping back CTS/RTS pins 4 and 5 on a 25 pin connecter. Also DTR, DSR and DCD (pins 6, 8, and 20) may also need to be looped back.

What works for me is a simple rs-232 cable (NOT A MODEM CABLE) that is wired

This is for a 25 pin to 25 pin

Computer Printer
2 3 Trans to Recv
3 2 Recv to Trans
7 7 Ground to Grd
4 -
|
5

6 -
|
8 -
|
20 -

I always use Xon/Xoff Protocol when printing
to control the printer.

A straight thru cable will not work (modem cable). It must be a NULL MODEM Cable (that means pins 2 and 3 are crossed over in the cable. Your breakout box may also be doing that.

This discussion is closed to new replies.