Discussion Locked

problems with formatting a hard drive

0 helpful
12 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I tried formatting an old hard drive that is working before and i received the following message:
Trying to recover allocation unit 26,345
and after about 4/5hrs i received the message:

Format terminated.
what must be the likely cause of this problem, and is there a way of reviving this hard drive.

12 replies

by jereg

You don't say what type of drive or the manufacturer, so I can only guess and give you general guidelines.
It seems that the drive may have a bad sector. You could try using fdisk to clear the drive. Set it up according to the spec numbers ON the drive, not what the BIOS wants to setup. Go to the drive makers web site and see if they have a copy of Disk Manager, or buy a copy of Disk Manager. This program will fix/repair bad sectors. I've used it to fix drives other people thought were toast. You may also have a conflict with the BIOS in the PC you are using. Again, go to the drive mfr web site, and look for setup/formatting tools they have to download.

by william jay

Howdy,

The most likely cause is too many bad sectors found. As mentioned above, set the drive up according to mfr specs, re-partition and re-format . . .

by djent

The drive is probably toasted. Even if you could repair it why bother recovering a failing drive.

by blaine moore

It isn't a question of if a hard drive will fail, but when. They all start to break from the moment you first give one juice. Only a matter of time.

by gkheart1

Hi,
I also agree with the has bad sector answers
and may have multipe bad sectors or clusters!
If you fdisk it and repartition it then do a
disk surface scan. You will probably see that
the drive has problems. The surface scan should pick up the problems.
Regards, Gil

by c.mcfadden

as everyone has stated your drive has bad sectors so i suggest if u have patients let the scandisk run untill it finishes it will mark the bad sectors and the rest of the drive which is good can be used,just don't store any important stuff as sooneror later it will die.I had seen this lots of times from fairly new drive to old as dirt drives and some of those drives are still going to-day.

So have patients and good luck

by tim.doyle

If your drive is less than 3 years old just call the manufacturer and get a warranty replacement...if it came as a part of an OEM system then call them (assuming the PC is under warranty of course). If the PC is out of warranty but the drive is notthen call the mfr anyway...WD would not replace a drive out of a Compaq machine I took care of once because that part number was turned over to Compaq as an OEM device, thus making it Compaq's problem, not WD's; but both Maxtor and Seagate replaced drives for me, also out of Compaqs that had expired system warranties.

Basically your drive is dead/dying. Since you're in the process of formatting I'm going to assume there isn't any information on there you wanted anymore.

If its out of warranty toss it in the trash (or take it apart because its cool to look inside new things) and buy a new drive...if its old enough to be out of warranty I guarantee you can get something thats 5x greater capacity and pushes data faster than the old one. Check out www.spoofee.com for their daily specials...there's usually at least one HDD deal a week...like 120gb 7200rpm drives for $50.

by colin_mendonca

Your drive definitely has bad sectors.You could recover the drive information by third party software.your manufacturers website could be useful.
let me tell you that it could get really costly untill and unless the information you want to recover is really worth it.
you can also try using the mbr command

by wlbowers

Cut to the chase. You have a bad nasty head crash at allocation unit 26,345 and it can not recover and continue.

What you have is a rotating paper weight.

Lee

by zapas

Try to load hard drive formatting tools for Linux systems (or setup Linux).If this way not helped, the hard disk is physicaly damaged...

by wlbowers

To skip the BS and answer your question No! The drive is dead.

If you removed the case cover you will probably find a gouge on the platters from a head crash.

The drive during formating tried to map out this area and continue. The reason it gave up the ghost is there is too much damage.

As a Tech we have a saying. "Everything that breaks was working just before it broke"

Good Luck Lee

This discussion is closed to new replies.