Discussion Locked

processor/motherboard

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I HAVE A SOYO SYSTEM WITH A SY-7VEM MOTHERBOARD, AND JUST RECIEVED A CELERON 1.10 GHZ, 256KB L2 CACHE, 100 MHX FSB, FCPGA2, 0.13 MICRON PROCESSOR, AND WOULD LIKE TO INSTALL THEM TOGETHER, BUT I AM WONDERING IF THEY ARE COMPATIBLE WITH EACH OTHER, ASFAR AS THE POWER SUPPLY, AND THE POWER REQUIREMENTS FOR THE PROCESSOR, AS THEY MIGHT BE DIFFERENT THAN WHAT I NOW HAVE NOW, WHICH IS A CELERON 533, OR DO I NEED TO PURCHASE A DIFFERENT MOTHERBOARD.
THANK YOU FOR YOUR TIME AND ADVICE.

7 replies

by pschuvie

Basically that motherboard supports the 1.75v .18 micron chips, not the newer 1.475 .13 chips. This is per the basic information from the soyo spec page. So no it not intended to work together.

However, you might look around their site to see if there is additional information or guidance.
http://www.soyousa.com/sy7vem.html

by bigfootduck

hmmm. in my personal opinion if the fits in the hole use it... Socket is a Socket if they didn't want u to put one in there then they wouldn't have made them compatible to begin with thats y u can't put a 486 in a socket A.

by cbach1997

Answer #2 used to get people in a world of hurt. Voltage cores are very specific for dies of chips, and .1V excess can sometimes result in an overheating chip. Not to mention multiplier capabilities, bus speed capabilities, CPU ID registries, and instruction set compatibility.

It's hopefully obvious to many that you can't just go buy any memory strip that'll fit the slot and put it in and have it work. The same is true for processors and boards as well. So thank you, Answer #1.

This discussion is closed to new replies.