Discussion Locked

Proper fiber connection

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a very sloopy fitting SC connection to a piece of hardware manufactured by CNT corporation. By this I mean when you put the SC connector into the interface port you first plug in the SC connector and then you have to pull it half way out to make the link light appear. I have spoken with the vendor numerous times stating that I can vouch for the fiber however I beleive that the interface card is bad. To date I have plugged in 16 different SC connectors in this port and thay all behave the same way.
Has anybody else ever experienced this before. When the vendor looks at the line he sees CRC erros depeding on the amount of data being transmitted.
Thanks in advance for your recommendations

5 replies

by ulf c

The fact that you get the link up when you pull the connector half way out suggests that the power of the incoming signal is too high. This would be the case if you connect equipment with multi-mode interface to equipment with single-mode interface (which has a more powerful laser). I suggest that you check what type of interfaces you have on the equipment involved. If there is a mismatch, i.e. multi-mode in one end and single-mode in the other, then you need to use a multi-mode (62.5/125) fiber for the connection, and put an optical attenuator on the single-mode interface TX port (or the multi-mode interface RX port). Usually a 10dB attenuator works fine.

by tony.griscavage

Ulf C thanks for the info it ws exactly as you indicated. After 2 weeks of phone calls with different tech's from the different vendor's 1 senior tech said he would verify the port. Unknown to us at DCC nad some of the other tech's CNT makes this particular card with multi-ports both Sinlge and multi mode. It was switched to a multimode port and we have beenhappily ever after. So thank you for your promt answer. Sorry about the delay in leeting you know.

by tocolote

One thing that can cause this problem is dirty fiber or a dirty interface port.

Clean your fiber with denatured alcohol (not Wild Turkey) or a cleaning kit.

Check with the manufacturer about cleaning procedures for the interface port. Some are easy to do, others can't be done without some kind of tool.

Can you do a loop back on this port? Try it if you can, it'll isolate the problem some more.

by tony.griscavage

Yes sir the first thing I did was to clean the connectors, with 99% denatured alcohol as perscribed by a vendor. As it finally turned out it was plugged into a single mode port. Which naturally we have multimode fiber. Thanks for the info reaaly apprepicate it.

This discussion is closed to new replies.