Discussion Locked

PS2 Mouse Port - pinouts required

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have an AT motherboard that has a 5 pin connector for a PS2 mouse port. I have obtained a suitable PS2 connector/cable assembly, however the 5 pin header wiring doesn't match the pinnouts on the motherboard so I need to rewire the header. Does anybody out there have a pinnout diagram for a PS2 port???

Thanks.

Bob (bobross@dove.net.au)

6 replies

by wanabedrsean

1 data
2 reserved
3 GND
4 +5V
5 clock
6 reserved
Also used for PS2 mice, they are interchangable except for the data format below is a pin number assighnment for the port the pipe symbol or vertical dash corosponds to the key part of the connector as your looking into a male connector

5 | 6
3 4
1 2

This discussion is closed to new replies.