Discussion Locked

PS2/USB ports dead

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a few computers around at my company whose ps2 ports just seem to have died. Some of them work very rarely. I thought I would be ok with usb keyboards and mice but then they lost power as well! Seeing as the ports are connected straight onto the motherboard I don't know how to check the power of them. If anyone has any ideas I would be very appreciative.

3 replies

by thechas

The PS/2 ports are OFTEN damaged by hot plugging devices.
The actual IC that handles the data signal is damaged.

For both PS/2 and USB to go out, I wonder if some users have port powered devices that are drawing too much current from the motherboards.

5 volt DC is on pin 1 of the USB port, and Pin 4 of the PS/2 port.

Ground is pin 4 of the USB port, and pin 3 on a PS/2 port.

As far as tracing it back if the voltage is low, good luck!!!
Most motherboards are made up of several layers of circuitry. Without a GOOD schematic for the specific motherboard, it will be VERY difficult to trace the 5 volts and ground lines back to their source.

Starting at the connectors, look for burnt or discolored components.
Look around the voltage regulator circuits, and back to the power supply connector.

If you are VERY fortunate, there may be an in-line fuse. These look nearly identical to the resistors and capacitors on the motherboard. So, they are still hard to find.

Chas

This discussion is closed to new replies.