8 replies
by bax2x Accepted solution
by bax2x Accepted solution
by bax2x Accepted solution
http://www.seagate.com/staticfiles/images/support/en/us/mxo_ata_jumpers_rev.jpg
http://support.dell.com/support/edocs/storage/50xfr/jumpers.htm
According to the datasheet lct10 and lct15 drives should have the same jumper settings.
by bax2x Accepted solution
by bax2x Accepted solution
by willcomp Accepted solution
CLJ is Capacity Limiting Jumper --- limits capacity to 32GB on 40GB and larger drives for compatibilty with older BIOSes.
Only a single jumper is needed for your drive. Horizontal jumpers are in storage position (not connected).
Jumper drives as Master and Slave rather than Cable Select (CS) and see if that helps.
To ensure cable compatibilty when using CS, you will need an 80 wire, 40 pin IDE cable.
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending