Discussion Locked

RAID 0 or RAID 1 for IDE Drives

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have just set up a new system. The motherboard has two IDE Raid connectors and two conventional IDE connections.

I have purchase two maxtor 80GB 7200 rpm ATA 133 hard drives.

How do I configure this system for RAID?

Example: Each drive connects to one connector?
Both drives get set up as master or
slave or one master and one slave?

Can anyone direct me down the right path?

7 replies

by timthetoolman

Hi,

Each on its own controller is best.
Both Master.

Use Raid-0 for speed and maximum disk space. You'll get 160Gb that way and the data will be evenly distribited (striped) across both disks. This method is faster for reading and writing. It'll fly.

Or Raid-1 for safety. You only get 80Gb but wont lose anything if one of the disks fails. The data is duplicated (mirrored) on both disks. This method is slower for writing but faster for reading.

I have a similar setup and mine is setup as Raid-1 as I dont want to lose my development work if a disk fails.

Cheers,
Tim.

by paulp

An additional note to answer #1 - in a RAID 0 setup, where the data is striped across both drives, you will lose the contents of BOTH drives if one drive fails.

If you're concerned enough about backups to use a RAID configuration, RAID 1 is the better choice.

by rick blaine

Hi, Thank you for your response. Sorry it took so long to reply however, I have only recently completed fine tuning my new systems and I am happy to report my RAID array is working fine. I chose RAID 0 for fastest response and total hard drive space capacity

This discussion is closed to new replies.