Discussion Locked

raid

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I want to create a Raid fault tolerance on my Nt server. How do I do it?

6 replies

by colster

You need a couple of things.
1) A RAID Controller (i.e. StorageWorks)
2) Disks
Depending on your RAID level will determine the minimum number of disks you need. For example RAID 0 requires no extra disks but RAID 5 you would want at least 4...formore info check here: http://www.raidarray.com/raid1.html

However you can use a Software RAID controller but they are not as redundant.

Have a Better One

Colster

by s_pryce

Use a RAID controller, Software raids are very good idea, cause more problems than they solve.
With a RAID controller chose either RAID-1 mirror (need 2 drives) and its the best in terms of performance and reliablity. Otherwise have a RAID-5 stripe(need 3 or more drives) and stripe the data across the drives, one fails it keeps going.
The other RAID levels are used anymore and can be disreguarded.

by scottsman

Just a note RAID1 is not the fastest. RAID 5 is the fastest and most redundant. you need the RAID adapter and at least 3 drives. adaptec 2100s is a good scsi raid card. they also produce an IDE Raid adapter that can support 4 drives. if you buy hot swap bays for each of your drives you do not even need to shutdown your system to replace a failed drive.

We use 4 drives with one as a hot spare that automatically turns on in case of a drive failure.

This discussion is closed to new replies.