Discussion Locked

Raid 5 DPT Contoller

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

On 7/14/00 I installed a DPT SmartRaid Controller (PM1564U) into a new server. The server operating system is NT4 with service
pack 5. The Raid 5 Cluster is 4 each Seagate Barracuda ST318416W 18.4Gb SCSI Drives. The system has been operating without any problems until 3/8/01.

The first occurrence of an error occurred on 3/8/01; the following are the error messages in the NT system event log file:
"A strip set or volume set member listed in the configuration information was missing." (thiserror was listed 3 times)
"A FT set containing \Device\MissingParityStrip1Member0 cannot be
used."

On 3/15/01; the following error messages:
"The previous system shutdown at 3:38pm on 3/15/01was unexpected"
"The fault tolerant drive detectedthe system was shut down dirty"
"A strip set or volume set member listed in the configuration information
was missing." (3 times again)
"A FT set containing \Device\MissingParityStrip1Member0 cannot be
used."

The exact same errors (as on 3/15/01) have occurred again on 3/21/01 and 3/22/01.
The error logs in the DPT Manager have been reviewed and there are no problems listed. Any suggestions on how to troubleshoot this problem would be appreciated.

6 replies

by william j sosville

Use performance monitor to check the Logical Disk and Physical disk counters to determine which drive is failing (if in fact a drive is failing)

Also If you have updated to SP6 or 6a you may need to obtain updated SCSI drivers.

by dave.sanders

Performance mointoring has not revealed the cause of the failure. I had also installed the most current SCSI drivers.

by akula

Since your RAID array was working well before, this may not be the problem, but I throw it in anyway...

In the September and November 2000 issues of Maximum PC, they showed massive problems getting DPT RAID controllers to play nice with Seagate SCSI drives. I don't know if this is causing your problem, but you may want to look at the controller itself if all your drives check out OK.

This discussion is closed to new replies.