Discussion Locked

RAID Setup

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have been in the hardware field for a couple years now. This is the first time I am going to install a RAID setup. I am familiar with what RAID is and the difference between SCSI and IDE. My question is how do i go about physically setting up a SCSI RAID? I have an ASUS P2B-S motherboard with on board adaptec SCSI Controller. I also have an Advansys PCI SCSI Card. What should i use the on board or the PCI Card. I am going to use either 2 or 3 SCSI Drives. I have 2 68 pin drives 1 50 pin Driveand one 50 pin SCSI CD-Rom. How should I connect the drives they are all about the same size does it matter which one is master and which is Slave. and Will i get any issues from the SCSI Chain if i have 68pin and 50pin drives on the same chain?

4 replies

by joseph moore

Well, unless you are gonna run a software RAID (Win2K/XP/2K3 can do this), you will need a RAID controller. It is a separate card that will control the RAID setup and drive usage. This would be a hardware RAID.
So, what type of RAID are you shooting for, software or hardware?

by spike50s

I was planning on putting Win2K on it. I just thought that hitting the F6 key during the set up was a little too simple I just thought there had to be more to it. Should i use the card or on board? Can i put the two 68 pin drives on one cable and the 50 pin drive and 50 pin cdrom on another, or should I connect the cdrom using IDE, would this cause and hardware conflicts on the chain?

by pctech

The onboard Adaptec SCSI controller will give you a keyboard combination to use, such as + C, to enter the configuration utility to set up your raid array. The SCSI BIOS controller will display a menu, after the systen POST, displaying thekey combination to enter the set up utility. If you truly understand raid confiugrations, this is fairly straight forward to set up. When you start an NT, 2000, or XP installation you will press F6, when prompted at the beginning of the install, to install the SCSI card drivers. Win9X and ME will also allow you to set up the SCSI card drivers sometime during the installation process.
I hope this helps you.
BTW, Adaptec make an excellent SCSI controller card.

This discussion is closed to new replies.