Discussion Locked

Raid Technologie

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
We already configure Raid Controller to Raid Level 5 and working fine, suddenly the raid configuration is missing, how we can recover that missing configuration, thank you

7 replies

by djent

That is a function of your controller utility software, read the docs and contact the vendor.

by cglrcng9

Check your program listing for a "Fast Check Monitoring Utility", you may need to rebuild the array. During boot up there should be a command to enter the array setup config. utility.

by bagmaster50

Is the raid controllers built into the motherboard or a pci slot based card? If thier builtin, the raid setup has to be reconfigured in the bios. If it's pci slot based controllers, you'll have to boot to an OS on a hard drive configured on a standard ide controller then run the raid setup from windows. Once set up again change boot sequence in the bios to boot to the raid and see if it boots. If it doesn't then you may have to image the OS back onto the raid setup.

This discussion is closed to new replies.