Discussion Locked

RAID to replace SCSI drives on 2k srvr

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Currently have a Dell Poweredge 1300/200 sql server with two 9 gb Seagate SCSI drives that are running out of space. One of them is just a mirrored drive. There is not an extra bay in the PC to fit another drive. I already bought two 18 gb Seagate SCSI drives to replace the others. I can't afford to buy Ghost Edition 7.5. and I have heard that regular Ghost Edition may not copy all settings on 2000 server. There is already RAID card (0), but I need a quick education on RAID and any other advice. Thanks!

8 replies

by cg it

SCSI is a better. To bad your mirroring your SCSI drives as you could just stripe the two additional SCSI drive into your system. Since you don't have any more room in the case [how about a better case?] Antec's SX 1030 server cases [or the Chieftech versions] can handle 4 HHD's in 2 ea internal 3 1/2 bays. The Chieftech case that is the same as the SX 1030 [without a power supply] can be had for about $80.00 including shipping from Newegg.com. A far cheaper alternative than risking losing dataand giving up the performance SCSI offers by going to IDE RAID.

by cg it

note: when I say SCSI is better, SCSI isn't limited [for all practical purposes]on the # of drives you stripe. Further, data transfer is much faster using SCSI than IDE. There are many other advantages to using SCSI than IDE but not necessary to mention to answer your question.

by djent

You don,t need Ghost if you have tape backup. Break the mirror, partition the 18GB drive to suit, restore backup to new drive, do a second install of W2k to WINNT2 Dir on new drive, edit boot.ini to use old install. You can delete or keep the secondW2K for repair purposes. Now install second 18GB drive and mirror. Also Adaptec has SCSI raid controllers, external drive cases can hold as many drives as needed, connect via external SCSI port.

by leehellcat

This may sound just a little heath robinson, but for the purposes of copying the data accross from the current mirrored stup to the new disks, why do you need to mount them in a bay, just leave them loose on the bottom of the case for the few hours it will take to do the copy ??

Also, you said that you have a raid card in the Dell already, go to the following site for some more information on Raid :
http://www.acnc.com/04_01_00.html

This should help you understand the different types of Raid and which is most suitable to your needs.

This discussion is closed to new replies.