Discussion Locked

RAM Memory

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I purchased 256MB DIMM from the local dealer and tried it in my computer and it would not work (motherboard about two years old). I took the memory back and the vendor exchanged it for what he said was a "higher grade" and told me that the density was to big on the first memory they sold me. I took the exchanged memory back and it worked just fine.

I have never heard of "density" as a term being used in conjuction with RAM memory.

How is density used with RAM memory??

Thanks,

Don

6 replies

by cg it

The terms Low Density and High Density refer to the # of chips contained within a memory module. If you will note the # of modules contained on a memory "stick" both front and back, you'll see on most high density memory boards modules on only one side. This substantially decreases the cost of manufacturing memory. However, older BIOS's and chipsets may have a problem addressing memory chips on a high density memory module [which seems to be in your case]. A workaround is to upgrade the BIOS and chipset of your mainboard. For further technical information, see the FAQ's on most major memory manufacturers web sites. Kingston has a good non technical description of high density memory.

by cg it

Thanks TheChas. Your the premier hardware guy. An added note: SIMM DIMM terms are single inline memory module, Double inline Memory Module respectively. Memory modlues are those black[usually] squares you see on the memory board. Within are the chips which store the data. Those chips have addresses so the computer knows where they are and when it put data. High density means "LOTS" of chips and some BIOS's and chipsets can not read or remember where a large amount of chips are within each module in the line on down the memory board. Older SIMM and DIMM boards had memory modules on both sides [took up space] which, in manufacturing terms, required two boards "put" together to form one board [multilayered boards]. This required a lot of mfg steps to accomplish and hense memory was very expensive. With new technology and mfg, a large # of chips[what normally in earlier days would take both front and back of a board] could be place in one module. This , as I said above, substantially decreased the cost of making memory. no longer was the need to have multilayered memory boards and took out half the steps required to make memory.

by thechas

DR has it all pretty well covered.
Over the life of SDRAM DIMM modules, there have been a number of changes, and not all DIMMs function in all motherboards. Even with BIOS upgrades!

First, there are DIMMs with 2 clock lines, and 4 clock lines.
Then, the original itteration of DIMMs are 'single' density.
Followed by dual or double density.
The latest itteration is quad density.

I keep on hand a 128MB single density DIMM just so I can verify if a motherboard has limits dealing withnewer DIMMs.

This type of change also happened years ago with the 30 pin SIMM memory modules used in 486 motherboards.
The 'most' compatable modules had 9 ICs on them.
(1 IC for each of the 8 BITS plus a parity IC)
There were the cheaper 3 IC SIMMs that worked in most, but not all systems.

Chas

This discussion is closed to new replies.