Discussion Locked

Reconfiguring an Old Gateway

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have an old Gateway P5-60. It has a Sony CDU33A-GW cd rom drive. My problem is that we reformatted the hard drive and now wish to reload win 95. Trouble is that the CD ROM isn't recognized when booting up. Cables are tight, power is there, driversattempt to load from Win 95 boot disk, but the CD is not found. It does have a proprietary card. Are there BIOS settings that I am missing? I'm lost

7 replies

by dmiles

You need a a boot disk for the cd-rom
Go to DOS prompt and type format a: /s,this will make floppy a system disk
Copy the driver for your cd-rom and the file mscdex.exe (found in the c:\windows\command directory) to the disk
Go to notepad or typeEDIT in DOS to open a text editor
Type DEVICE=A:\NAME OF CD-ROM DRIVER/D:NAME of CD-ROM
Save this file to your boot disk as CONFIG.SYS
Next click on the new file menu,in the blank windo type A:\mscdex.exe /d:name of cd-rom /L:d

by kep 001

There are settings in the BIOS that affect the CD ROM. However, if you did not change the CD ROM, the hard drive, any of the cables or IDE ports I can't see that this would change just by reformatting the hard drive. If you did change out any of these you would need to verify your cable location (master on the end, slave in the middle), your master / slave jumpers on both the hard drive and CD, and your IDE port (both location and BIOS settings for that port.

If the hardware was not changed, however, I would suggest that you load DOS 6.22 and load the CD's DOS driver and then load Win95.

Kep

by bryan_hartman

All Gateway computers i have worked on the CD-Roms seem to go bad quite often. Try swapping the cd-rom with a known good one.

This discussion is closed to new replies.