Question Locked

recover files from a dead laptop

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

My old laptop, a dell B120, is broken. Now I put the harddisk in a usb enclosure and try to access the files but the new laptop can't detect the harddisk. It won't show up in Disk Manager. The hard drive was spinning and the usb slot can read a different thumb drive. Both laptops run XP.

1) the old hard disk is a MP0402h, made in 12/2005 (that's the only date on the label.) I can't find the interface type, but it should be IDE compatible, right?

2) the old laptop had a system password before loading XP and had passwords for user accounts. Is that the reason why it cannot be detected?

Thanks in advance.

9 replies

by the 'g-man.'

how is it broken, what happened?

Did it suffer a disk failure?

by martinvi

The laptop couldn't get power from AC, worked with battery. There was also problem with the display. Then I opened it up. It's broken.

by tintoman

I suspect that the bios settings do not allow USB mass storage devices to be connected.
You need to boot the computer to the BIOS settings to check this, and make sure that you configure the USB controller to allow mass storage devices but the select the option to "NO BOOT" otherwise the computer freeze whenever you start it or shut down with a usb device connected

by martinvi

The new one isn't a dell, but it recognizes a memory stick as USB mass storage/USB flash drive. When the harddisk is connected, it sees USB mass storage (which it sees even without the harddisk, just the enclosure). And the ballon helper says "new hardware found"... "new disk"... But there's nothing in MyComputer/explorer/DiskManagement.

by tintoman

that your hard drive has an internal fault preventing the flow of data or the file structure is damaged on that drive.

by martinvi

why can't it not be that the usb enclosure is faulty? If both the harddisk and the enclosure are fine, the new laptop should be able to see it, i.e., the MP0402H is IDE compatible and the password can't prevent the disk from showing up, right?

by deadly ernest

most of them have a little internal control board and some will only work with discs of up to a certain size or a certain model as that's what they were designed for. the other thing is to make sure the enclosure works with your current system with another drive in it as you may need special drivers for using that enclosure - some do have that issue with MS Windows.

I use a drive docking station for this stuff myself, like this little baby

http://www.computeronline.com.au/products.php?C_ID=3&S_ID=83&PROD=20069

by martinvi

It says it works with IDE harddisk and no drive installation is required for XP. Well, I have backup of the important files, so it's not a big deal.

This discussion is closed to new replies.