Discussion Locked

Removing slave harddisk prevents boot?

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am running Windows 2000 Pro with a Primary Master and a Primary Slave harddisk. If I remove the Primary Slave disk my pc stops booting during the autodetect process of the POST. Can anyone tell me why this happens and how I can remove the slave disk.

7 replies

by brian

try going into your bios and manually selecting your Hard drive configuration. This allows you to autodetect drives so you can do that for the master. Then set the slave to disable. This should remove it from the bios while not affecting the other drive.

by brian

You might want to use the WIN2k CD to boot and then choose to repair the installation.

by thechas

Did you reset the jumpers on the primary master drive?

Many hard drives require a different jumper setting when used as a single.

I know first hand the Western Digital drives will not boot as singles when the jumpers are set to master.

by purplebook

As answer number 1 stated, go into BIOS and under the first settings choose NONE for the Primary Slave drive. In all likely cases, the machine is trying to see that drive even though it isn't there any longer. By telling the BIOS that there isn't a drive there, it will boot without timing out looking for it.

by tsimmo67

When the computer boots up go into your bios and change the boot settings until the bios says that the boot is of the ide that you have your master disk on, probably IDE-0 that is the normal config, as the computer is most probabaly trying to boot of the slave disk

-Travis

This discussion is closed to new replies.