Discussion Locked

Repairing a dead HP Laserjet 5

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My school's LJ5 acted up just as the term ended, requiring us to spend $$ for a new laser printer. The LJ prints solid black horizontal bars across each page, even on printer-generated test pages. Can this sort of behavior be fixed (cheaply!) or should I just junk the old boy?

5 replies

by ann777

Pull out the toner cartridge and look on the roller inside the flap. If you see a black streak along the roller, then replacing the toner cartridge will resolve it.

If you don't see anthing on the roller, then it's probably the fuser. Either the fuser has gobbs of toner (or other things) within, ir the fuser drum is gouged. Fusers cost a couple of hundred of dollars, but are easy to replace if you can order one.

by johnm

If the bands are consistently about 3"-4" apart, the problem is probably in the toner cartridge.

If the bands are irregular in spacing and width, there is a good chance that your High Voltage Power Supply ground connection is loose. If that is the case, turn off the printer, give it 15 minutes to cool and to discharge the HVPS and then gently tighten each of the grounding screws for the HVPS, taking care not to strip the threaded holes. Check the High Voltage wiring harness for crimps orshorts. If all else fails, replace the HVPS. (Bigelow's Printer Troubleshooting Pocket Reference, McGraw Hill)

by johnj

Thanks. I have taken steps to see that the printer gets to the shop. Hopefully it can be resurrected. The bands were irregularly spaced.

This discussion is closed to new replies.