Discussion Locked

Replacing a RAID HDD

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a client that has a 3 HDD RAID 5 system (0, 1, 2). The HDD #2 failed and was replaced but it is not part of the other two yet. The O.S. can see the first 2 as one drive but the third is separate and can not be accessed. I am new to recovering a RAID HDD.

5 replies

by stress junkie

Fortunately the task of replacing a RAID disk is pretty
much the same regardless of whether you have
hardware only RAID, sofware only RAID, or RAID that
uses both hardware and software. I've done this many
times on different platforms. Assuming that you don't
have a stand alone storage array then these are the
basic steps.

1) Identify and run the RAID management software
that runs under the operating system.

2) Use the RAID management software to format the
new disk.

3) Use the RAID software management software to add
the new disk to the RAID set.

4) Use the RAID management software to rebuild the
RAID set.

It's really just that simple. If you need more details
then post a reply to this reply stating the information
that you need. More information from you will help.
Details such as operating system and RAID
manufacturer will be critical to providing more detail.

Cheers.

by stress junkie

Ooops. Step 1 is ALWAYS to perform a full backup of
the RAID set before messing with the configuration. I
don't know how I let that slip.

by stress junkie

I should have finished my coffee before I wrote the first
reply.

You have to add the new disk to the RAID set and then
format the new disk and then rebuild the RAID set.
This is because the way the RAID software formats the
new disk depends on the configuration, so the RAID
software has to know that the new disk is part of an
existing RAID set in order to know how to format it.

Sorry about that chief. I really think I've got it right
this time.

by daryl russo

Thank you for your help.

I am not sure of any program from Windows that will do this and the SCSI RAID utility does not help in formatting or setting up the additional hard drive. That is what I can see with no experience of ever doing this before.

What should I look for?

by stress junkie

I can only provide the basic steps. If I tried to do more
I could lead you astray with disasterous results. I
recommend reading the documentation with the SCSI
controller and the documentation with Windows.

This discussion is closed to new replies.