Discussion Locked

request for help

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

how can i change resources (irq,i/o )by the windows.
i install modem of lucent, that takes IRQ 15.
IRQ15 is already reserved for IDE controler.
every time of instalation it takes IRQ15
i want to chang in the windows. how can i do?
Kindly helpme for this purposet
thanks
Tariq

9 replies

by semi-pro 64

Go my computer, right click, and go to properties. There should be a button called device manager. Under this, you will have a list of devices; right click on the device conflict in question, and select properties, select the resources tab. Be care with this, I might try and change the modem's IRQ because if you mess it up, you can still work. However, if you mess up the IDE controler your harddrives may not work.

by vorsossion

Using the above proceedure, try and move your modem to IRQ 3 or 4 which are designated for your communications ports. One of these two should be available.

Also, is this a replacement modem? If it is, have you removed the old modem from your device manager? If you have not, your computer may think the old one still exists and so cannot install your new one in the right IRQ and Com ports.

by mrgeorge

IRQ 15 is actually reserver for the second IDE controller so if you only have two IDE devices that are connected to the same primary IDE controller, you can go into your BIOS and disable the second IDE controller and use it's IRQ for the modem as itis.

This discussion is closed to new replies.