Discussion Locked

restore in window xp

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have to restore my harddrive because it is not recognizing my cd and dvd drives. It is 2 months old and Best Buy technican tested it and said I would have to erase the drive and start anew. He failed to tell me how and I have been trying to figure out but xp is not very helpful. I can not use the Restore CD since it is not recognized. It was considered my fault since I was trying to install a third drive and I guess computer got confused. I should have just removed the one DVD drive and installed the DVD writer in that spot. Could you tell me how to make a reboot disk in windows xp and do I need a windows xp disk since I did not get one with the computer?
I have a vpr Matrix pc with Pentium(R)4CPU 2.40GHZ
512 MB of RAM.
Thank you
Nancy

9 replies

by paulp

Have you tried the XP feature which allows you to return your computer to a previously known good configuration?
I'm not at my home XP PC right now, but if you go to HELP search for RESTORE and winXP will guide you through restoring your PC to a known good configuration.
Hope this helps.

by thechas

The 'restore' CD is an image of the hard drive as loaded at the factory.

There should be a procedure to boot from a floppy, or the CD to replace what's on your hard drive with whats on the CD.

If your motherboard and CD drive both work, you should still be able to use the restore CD.

If your CD or DVD drive is not recognized by the BIOS, that is a hardware problem. You have to correct that hardware problem first.

Once the drives are recognized by the system BIOS, you can try installing the IDE driver for the motherboard. That may correct the problem.

XP is a little pickier than previous versions of Windows when it comes to hardware changes.
It is almost a requirement to remove hardware from device manager before physicallyremoving or changing how the hardware is connected.

Have you tried removing all the drives from Device Manager, and going back to the original configuration?

If you connected the new drive to the same IDE cable as your hard drive, you may needto change jumpering on the hard drive itself.
Many HDDs have different jumper settings for Single drive and Master with Slave present.

Chas

by s.milhouse

Try going to www.bootdisk.com. The site will walk you through creating a set of XP boot disks depending on which flavor of XP you are running. Home or Professional. Good luck!!

by deadly ernest

Why not just return the hardware configuration to the state it was in when you lasted booted OK and reboot it in that mode and then 'remove' one device within the Xp Device Manager and then physically chaneg teh devices and allow the system to automatically find and load the new device?

You may have a different situation to us here in Aus, the software we get with the system is supposed to be a full copy of the operating system so you should be able to just do a rebuild from the cd using 'boot from cd' in the BIOS. It sounds like you have been given a cd 'image' of your PC, this would normally require a floppy 'boot disk' to match the imaging software used to create the image.

Dont know about US law, but here in Aust you can demand the XP disk that was originally loaded onto the system.

This discussion is closed to new replies.