Question Locked

Restoring an Image to a RAID configured Workstation

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I used Symantec back up exec V 8 to create an image of a critical use PC, then I tried to restore to a more robust workstation using raid 0. The restore worked, however the old OS does not recognize the drive configuration. is there some way I might be able to convince the new machine to work?

3 replies

by Former member

You will have to a restore on to a hdd and then copy this over to the Raid0 drives. Then go into the bios and select the Raid drive in question and see if it boots up.
A bit of a pain but that is what i used to do.
Until i got bigger drives, now i do not use this Raid utility unless it is Raid5, then i will use it. With a Raid5 set up your data is saved across many drives and you can swap out any drives (up to two) and not loose data.
Hope all goes well.

Please post back if you have any more problems or questions.
If this information is useful, please mark as helpful. Thanks.

by r_carrison

The symantec software was used to create the image on a Network Arrayed Storage device. The recovery then copys that exact image back to the New machine's drive. Of course the new machines raid drivers invoke before the OS, and it doesn't see an active partition. I tried disabling the SAS 6 controller in the bios, but then the machine says there are no configured drives.

This discussion is closed to new replies.