Discussion Locked

revive a hard disk

0 helpful
13 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
how do i revive a faulty hard disk

13 replies

by rngara

Wrap the hard drive in a plastic bag and put it in a freezer for about8 to 12 hours, take it out and connect it

by blackcurrant

Hi

Can you say what the symtons are? If you can give specific details of any error messages (or lack of them!), we can tailor our responses to your needs.

by dcoyle

Try these:
As in Answer 1, put in the freezer (in a bag), but 1 to 2 hours is all you need. It condenses a bit, when you put it back in the PC, but don't worry about it. Boot up immediately.
If above don't work? Tap lightly with a hammer.
Try it now. IF no good, give it a few more harder knocks!
Worst comes to worst, it may make sense just to load the HD as a slave in another PC. Boot up, assuming you have the jumper(s) correct...and you should see it when you d/click My Computer eg. it could be drive E. Take the info off it, that you need and discard this HD. If all you see on this drive (presuming you do see it) is Garbage, then you are in trouble! Good Luck. Hope this helps; I use this all the time.

by dmiles

Check the TechRepublic article 200 Ways to revive a hard drive that was posted in the early part of the year

by opatzg9

another quick fix is remove the hard drive,hold it firmly in your hands and snapit down sideways in the air, what you're trying to do is to get the spindle to let those circulr plates to spin again. You don't want to be to violent with it and personally, a hammer will never fix the problem but it may make you feel better. Normaly they fail because they aren't spinning from a build up of junk stopping the spindle from letting the motor turn it or whatever lubricant is used starts to fail. either way it's time to back up and replace. It makes a good secondary drive for anything you don't care if you lose.
Good luck

This discussion is closed to new replies.