Discussion Locked

Ricoh MP7040A into Hewlett Packard

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have an old HP Pavillion 8513 Pentium 3 500MHz and have recently purchased a Ricoh MP7040A burner.. I have tried to designate the burner as the slave drive and the cdrom as primary. Do I need to get a driver for the burner or is this a hardware conflict problem.... or something else??

7 replies

by parvus1202

You have a P3, almost all CD writer still recognise as old as P2. You need driver to run it, and a burning software to use it, like Nero 5.5 or Easy CD. But, what is really the problem? What happened after you have designated each to its own?

by djent

You need burner SW. I suggest that you setup the CDROM as a slave on the primary IDE buss and the CDR on the secondary IDE buss as primary or slave, no difference. You cannot address two IDE devices on the same buss concurently, this will improve CDR performance, reduce buffer overflow errors and reduce wasted CDs. I prefer SCSI CDR drives for the same reasons.

by rcom

Windows should see the burner if installed correctly. When you say designate do you mean set the jumpers? There's jumpers on the back of the drive that make them a slave or master it's usually stamped on the drive explaining the jumpers. Slave is inthe middle. If you have done this try CS (cable select)

This discussion is closed to new replies.