Discussion Locked
0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Why won't any RJ-45 plug into the NIC when I haven't had any problems with it before?
7 replies
by vinnyd
This happens a lot with some computer cases.
take the cover off
Loosen the screw holding the board in
plug the cable in
Tighten the screw.
Poster rated this answer
by tocolote
If it's a new cable, make sure that it's not keyed. RJ-45 cables for special applications have tabs on the side.
If it's not clicking into place, try gently lifting up the tab on the top just a little bit. Or if you kicked the stupid computer, the card may have shifted and you'll have to readjust the card to allow the RJ-45 connector to fit in the slot properly.
Poster rated this answer
by kmerrillt
It sounds like there is probably a small piece of something (maybe part of an connector) stuck inside port on the card. Maybe even a piece of a broken lock tab from when a cable was removed. Look very carefully. Otherwise you can remove the card and see if the connector will plug in with nothing around the card. Make sure one of the wires in the card is not bent.
Poster rated this answer
This question was closed by the author
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies