Discussion Locked
0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
How Do I Config? So I Can Run 2 Hard Drives At The Same Time.
5 replies
by thechas
Well, your question is a bit cryptic, here goes 2 possible answers.
Normally, you setup one drive as the master, and the other drive as the slave on the same IDE cable.
The master will be drive C: the slave will be drive D:
If you want to have 2 drives act as a single large drive, you need a RAID controller.
Both drives MUST be the exact same make and model.
Then, set them up as a RAID 0 array.
Chas
by jgronda
Poster rated this answer
by djent
If you are concerned about concurent operation the drives must on different controllers ie: PRI/SEC. IDE does not support cuncurency on the same bus.
by jgronda
Poster rated this answer
by jgronda
This question was closed by the author
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies