Discussion Locked

Running drives using additionl pwr sply

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My power supply is only 140 watts. I have 2 hard drives, 1 floppy, 1 CD-Rom. I tried to add a CD-RW and my computer would not boot up. Can I add another power supply just to run the CD-RW? If it can be done, how would I hook everything up?

11 replies

by dmiles

No you cannot rig a power supply up in daisy chain,Get a new power supply and install internally in the system
You will only cause your self the lose of a computer

by Former member

The question was auto-closed by TechRepublic

by csmith

The above answer is not correct.
The first possibility is to use an external case for the CD-RW and hook it up to the USB port.
We put two power supplies in parallel on most servers.
The main problem is the amount of current the drives draw when the PC starts.
There is a big surge of starting current as drives spin up, and the capacitors charge on the MotherBoard.
The cheapest solution is to change the power supply, because power supplies are so cheap.
This applies only if you have a industry standard case.
If you have a case that takes an obsolete proprietary power supply, an external case is the best option.
Almost all external cases come with their own power supply.
Make sure it is a case for 5 1/4 drives. We have external cases that take only 3 1/2s.
(They are usually used for external SCSI RAID 5 arrays, when the server case has run out of room.)
Regards, Chris

by csmith

:
Note: I ignored the possibility of mounting a second power supply in your case, because, the possibility that you have a server case, which has mounting places for two power supplies, is very slim or none, since the original power supply was only140 watts.
I have never seen a server come with a power supply that small.
Regards, Chris

by csmith

Ans # 4 about replacing the CDROM with the CDRW is a good idea.
Regards, Chris

by Former member

The question was auto-closed by TechRepublic

by Former member

The question was auto-closed by TechRepublic

by jbhenson

(Are you sure you are connecting the new drive correctly? Improperly connected IDE drives can cause the computer to not boot.)
It isn't my preferred course of action but you can do it. The two main considerations are that the drives have power andthat they are connected to the IDE chain correctly. (Everything has to be grounded but not to each other.) The easiest way is to use an external case. Make sure it mounts 5 1/4 drives and move both CD's to it. Connect the ribbon cable from your computer just as if the drives were in the computer and make sure to power up the separate box before you turn on your computer. The exposed cable won't be pretty but it will work. (You can even use a old computer case and mount the drives in it.)
In your situation I would remove the CD and use the CD-RW instead.

by Former member

The question was auto-closed by TechRepublic

by Former member

This question was auto closed due to inactivity

This discussion is closed to new replies.